Plus I can't really change the settings of my R4, it seems that the Utility software doesn't connect to my R4 like it used to on my iMac. I used the Noctua NF-A4x10 FLX 40mm for the power supply and the GELID Solutions FN-FW09-20-B 92MM for the case, just as cfs.matt suggested. And now that I switched to a new Mac Pro which is almost silent the Pegasus had to be tuned. I always thought the noise level is incredibly high. I installed the last utility software and the situation has not changed. I also just replaced the fans in my Pegasus R4 (Version 1). It woks fine but I am not sure about the BIOS options.
I wrote 'the assumption is that you will gracefully unmount then physically disconnect/connect to the respective host (not simultaneously) using HFS+ on the Pegasus.
How to power off promise pegasus r4 install#
Do you suggest to install last utility and/or any firmware to solve my issues? With regards to 'My current approach is to plug one in at a time then power up the Pegasus.' Absolutely you cannot connect both hosts simultaneously. My Pegasus R4 was accepted by the system from the start, I didn't have to install any utility. When the system stops to work it seems that the trackpad is sending the 4 fingers swipe to change the show a different dekstop: very, very slowly my monitor shows this 4 fingers passage to Desktop 2. I already disabled energy saving options. If YouTube is on, it keeps playing and only audio buttons respond: I have to presso CMD + Shift + Q to log out of the system to make it work again. Do you have the same issue? I also noticed that after some moments of inactivity, the computer doesn't respond anymore. The only problem I have is that, strangely, my trackpad doesn't accept 4 fingers gestures when the R4 is connected (1 to 3 fingers gestures works great). The boot is slower when my R4 is connected, but not so much in comparison to Mavericks (with 10.9.5 I had to reinstall the old Promise Pegasus Kext from 10.9.2 or previous). I have to turn off the computer, turn on the Promise Pegasus and start the computer again. I installed Yosemite 10.10.3 and my Promise Pegasus R4 works just fine.
Building a CustoMac Hackintosh: Buyer's Guide
0 kommentar(er)
